KEENE IR DISTRIBUTION AMPLIFIER
Put your remote back in control and route IR commands to wherever they are needed even round corners and inside cabinets. Multiple input/output options (see components list below for more details) can provide a solution to almost any IR control problem. This kit, comprising the Keene IR Distribution Amplifier, 240V UK mains power adaptor, 1 x low power emitter wand (see output component [IRLPW] below), 1 x high power emitter wand (see output component [IRHPW] below), 1 x Standard IR receiver (IRSR below) and instruction leaflet.
Also available without the IRSR standard receiver IRBKIT
INPUT COMPONENTS
Standard IR Receiver 40kHz suitable for most domestic equipment.
IRSR
Wide Band IR Receiver Up to 100kHz for more esoteric equipment.
IRWBR
Standard IR Receiver wall plate. 40kHz suitable for most domestic equipment, built into a single gang faceplate
IRSP
Wideband IR Receiver wall plate. 100kHz suitable for most esoteric equipment, built into a single gang faceplate
IRSPW
Powermid IR lead To feed a Powermid RF receiver output directly to the IR Distribution Amp input (3.5mm stereo jack plug to 3.5mm stereo jack plug 1.5m long). KLDE6
Wavecom IR lead To feed a Wavecom RF receiver output directly to the IR Distribution Amp input (2.5mm stereo jack plug to 3.5mm stereo jack plug 1.5m long). KLDE10
Input splitter 1 x 3.5mm stereo jack plug to 2 x 3.5mm stereo jack sockets adaptor. Allows the IR Distribution Amp input to be fed by both a cabled feed (from say a Powermid RF receiver) and an in-room
IR receiver. KA109
OUTPUT COMPONENTS
Universal Wand. IR Universal Wand. Can be used in either low power or high power outputs. The dual emitter allows for equipment fascia or shelf mounting. Two are supplied as standard.
IRUW
Low Power Wand. Can be attached directly to the equipment facia or will work up to 4 metres away. Even when attached directly the equipment will still respond to external IR signals. Only to be used in the IR Distribution Amp low power output sockets.
IRLPW
High Power Wand. Will operate equipment from up to 10 meters away. Can also be used in the IR Distribution Amp low power output sockets if required, but will then only perform as a low power emitter. Not suitable for one-to-one operation. IRHPW
Side Firing Wand. A short range emitter for direct attachment to the equipment fascia. IRSFW
Dual Blinking Wands. The single jack plug drives two IR emitter wands. The emitters are extremely tiny (just 9mm across) and are supplied with double sided adhesive pads to affix directly to the equipment fascia. The emitters actually flash red as IR signal is emitted giving visual confirmation that the IR signal was received and transmitted correctly. IRDW
EXTENSION
Extension leads, 3.5mm stereo jack plug to 3.5mm stereo socket to be used on input or output as required. We've tested the input up to 10m and the output to 20m.
3m extension KLD40
5m extension KLD405
10m extension KLD4010
You can extend the input much further by using CAT5 cable and a pair of these adaptors
Have a look at the instruction sheet here (Acrobat pdf file)
For pricing and ordering information visit the Keene Electronics site 